found a hot one!
Posted: Sat Apr 09, 2016 2:55 pm
so the case feeder is all dialed in, all my dies are set - loaded a dumm 250 FTX up in an empty case, got the hornady taper crimp set for 0.475 to start off.
after setting everything up i went through and resized and punched all the primers out. came across one peice of brass that must have been a rather warm load. i couldnt raise the shellplate all the way up as it was hanging up on the lip of the sizing die.
you can see the ejecter hole, and the extractor rescess from the bolt face. i dont have the primer as i had already cleared them all out with the universal decapper before i decided to resize them and then tumble the primer pockets clean.
the case is buldged to .519 just before the extractor groove on the rim. it almost looks like a belted magnum!
oops - this little fella tipped over before getting into the shellplate and i was clearing a jam in the case feeder.
after setting everything up i went through and resized and punched all the primers out. came across one peice of brass that must have been a rather warm load. i couldnt raise the shellplate all the way up as it was hanging up on the lip of the sizing die.
you can see the ejecter hole, and the extractor rescess from the bolt face. i dont have the primer as i had already cleared them all out with the universal decapper before i decided to resize them and then tumble the primer pockets clean.
the case is buldged to .519 just before the extractor groove on the rim. it almost looks like a belted magnum!
oops - this little fella tipped over before getting into the shellplate and i was clearing a jam in the case feeder.