Moiecol wrote:Issues - 1& 2 (all testing phase only)
1 - Well it turns out the was 2.080 will do the plunk test. ( just learn that word from another thread) I used the Hornady comparator and the ammo checker to start. But the coal is the same as the 300gr FN load data which is 2.080 which I'm ok with that.
2 - I've set round in brass and will get a bulge on the side and some worse than others. The steps I tried new brass and new brass resized, with flare and no flare, bullets as is, and resized them. It's all-new Starline brass. I've done 2 pistols and 5 rifle brass with no problem. All thoughts ?
Mic (not caliper) the diameter of several of those Berry's you're trying to use. If they're more than .452, therein lies your problem.
The only time I ever encountered bulge was when trying to use cut down .284 Win brass. The walls were too thick back where they were cut down to 1.70.
Hoot