bigboreshooter wrote:Hey dawg how much would you charge for some of those bad boys, if I sent you the brass and had box of bullets delivered?
Due to liability concerns, and the fact that every rifle has small variations in chambers, I can't load for others. These loads MUST be carefully worked up in the rifle that they will be used in. I'm very sorry. But your safety is most important.
Also, for what it would cost you in the components, brass and ORMD/HazMat shipping costs, you could probably get a good start on a set of dies. I wished there was a short cut but fact is, QuickLoad indicates that these loads have the potential of exceeding SAMMI pressures.